3 Meter Non-Pyrogen Clip Igniters (25 Igniters), Choose Connection Option

Each unit contains twenty five 3 meter / 9.8 ft. wire non-pyrogen Talon electric clip igniters for the igniting a fireworks display with blue wire. 

Please choose between traditional stripped copper wire ends, or Quickplug connectors for systems (Ignite i18) and slats that utilize Quickplugs before adding to the cart.

Installation Tips:

The non-pyrogen clip igniters are designed to ignite fuse using a power source 12 volts or greater.

Non-pyrogen clip igniters should only be hooked to the firing system in parallel.

When installing the clip igniter onto the fuse don't move the clip up, down, or side to side once on the fuse. This will weaken or break the filament.

Move the wire from between the clip bending the wire at 90 degrees, open the igniter like a clothespin, place the fuse in the slot and close the igniter. Cutting off the extra fuse makes the igniter easy to tape in place but not necessary . Secure in place with tape so the igniter won't move, breaking the filament.

If a firing system is powered by an alkaline battery power source, weaken the fuse outer coating so the clip igniter filament ignites the fuse quickly. The fuse outer coating can be scraped off or a V can be cut in the outer shell of the fuse with a razor knife and the clip filament placed in the V cut in the fuse.

Use the clip igniters out of the original bag they come in, seal when not in use. The clips snag on one another as you pull them out of the bag.

Do not store the igniters in a warm environment or in direct sunlight. Store in the house not in the warm garage in the sealed plastic bag so the rubber bands won't weaken.

Non-pyrogen clip igniters can be safely installed on the firework before taking the product in the field so the user can spend less time in the field setting up a show.